Table 2-10Jetdirect menus (continued)

Menu item

Sub-menu item

Sub-menu item

Values and Description

 

 

 

 

 

 

 

Manual: Use the Manual Settings menu to configure

 

 

 

TCP/IPv4 parameters.

 

 

 

 

 

 

DHCP Release

This menu appears if Config Method was set to

 

 

 

DHCP and a DHCP lease for the print server exists.

 

 

 

No (default): The current DHCP lease is saved.

 

 

 

Yes: Release the current IP address. Note that the

 

 

 

printer will lose network connectivity until it reboots at

 

 

 

which point it may have a new address.

 

 

 

 

 

 

DHCP Renew

This menu appears if Config Method was set to

 

 

 

DHCP and a DHCP lease for the print server exists.

 

 

 

No (default): The print server does not request to renew

 

 

 

the DHCP lease.

 

 

 

Yes: The print server renews the lease on it's IP

 

 

 

address.

 

 

 

 

 

 

Manual Settings

(Available only if Config Method is set to Manual)

 

 

 

Configure parameters directly from the printer control

 

 

 

panel:

 

 

 

IP Address: The unique IP address of the printer

 

 

 

(n.n.n.n), where n is a value from 0 to 255.

 

 

 

Subnet Mask: The subnet mask for the printer

 

 

 

(m.m.m.m), where m is a value from 0 to 255.

 

 

 

Syslog Server: The IP address of the syslog server

 

 

 

used to receive and log syslog messages.

 

 

 

Default Gateway: The IP address of the gateway or

 

 

 

router used for communications with other networks.

 

 

 

Idle Timeout: The time period, in seconds, after which

 

 

 

an idle TCP print data connection is closed (default is

 

 

 

270 seconds, 0 disables the timeout).

 

 

 

 

 

 

Default IP

Specify the IP address to default to when the print

 

 

 

server is unable to obtain an IP address from the

 

 

 

network during a forced TCP/IP reconfiguration (for

 

 

 

example, when manually configured to use BootP or

 

 

 

DHCP).

 

 

 

Auto IP: A link-local IP address 169.254.x.x is set.

 

 

 

Legacy: The address 192.0.0.192 is set, consistent

 

 

 

with older HP Jetdirect devices.

 

 

 

 

 

 

Primary DNS

Specify the IP address (n.n.n.n) of a Primary DNS

 

 

 

Server.

 

 

 

 

 

 

Secondary DNS

Specify the IP address (n.n.n.n) of a Secondary

 

 

 

Domain Name System (DNS) Server.

 

 

 

 

 

IPV6 Settings

Enable

Use this item to enable or disable IPv6 operation on the

 

 

 

print server.

 

 

 

Off (default): IPv6 is disabled.

 

 

 

On: IPv6 is enabled.

 

 

 

 

ENWW

Use the Administration menu 27

Page 41
Image 41
HP M9050 MFP manual Dhcp Release, Dhcp Renew, Manual Settings, Default IP, Primary DNS, Secondary DNS, IPV6 Settings Enable