IBM 4.3-W manual Higher

Appendix A: Configuration

An inventory collects data about the network resources that the technology pack monitors. After you install an SNMP technology pack, you must create an inventory profile using the Inventory Tool Wizard and then initiate a discovery by executing the inventory profile using the Inventory Tool.

Running the initial inventory against SNMP objects is an intricate task and unfortunately beyond the scope of this configuration appendix. For instructions on using the Inventory Tool Wizard to create an inventory profile and the Inventory Tool to execute the inventory profile, see the Netcool/Proviso DataMart Configuration Guide.

12.Edit pack-specific UBA parameters, based on the following Netcool/Proviso platforms:

—443 and higher

—Pre-443

443 and Higher

In this release of Netcool/Proviso, you were instructed to modify the technology pack-specific UBA parameters when you installed the Cisco IP Telephony Technology Pack, using the Topology Editor. If you did not modify the UBA parameters with site-specific values or you want to make additional edits, you can do so now. Otherwise, you can go to the next step.

See the Installing Technology Packs chapter of the Netcool/Proviso Installation Guide for more information.

Pre-443

The Cisco IP Telephony Technology Pack requires specific UBA parameters that are not in the dc.cfg file. The DataChannel installer creates a dc.cfg file in the DATA_CHANNEL_HOME/conf directory (/opt/datachannel/conf, by default). These pack-specific parameters were delivered in a template file called voip_cisco_ipt_sample_dc.cfg.

The best practice on adding these pack-specific parameters to the dc.cfg file is to:

—Edit the pack-specific UBA parameters in the template file with site-specific values.

—Manually add them to the dc.cfg file.

To edit the pack-specific UBA parameters in the template file with site-specific values, follow these steps:

12-a. On the DataChannel server, change your working directory to the DATA_CHANNEL_HOME/scripts directory by entering the following command, replacing DATA_CHANNEL_HOME with the DataChannel home directory (/opt/datachannel, by default):

cd DATA_CHANNEL_HOME/scripts

12-b. Make a backup copy of the voip_cisco_ipt_sample_dc.cfg template file, by entering the following command:

cp voip_cisco_ipt_sample_dc.cfg voip_cisco_ipt_sample_dc.cfg.ORIG

12-c. In a text editor, open the voip_cisco_ipt_sample_dc.cfg template file for editing.

12-d. Edit the pack-specific UBA parameters according to the instructions provided in Appendix B, Template File Reference.

Note: The cross reference link to Appendix B, Template File Reference does not work due to a formatting limitation.

12-e. When you are satisfied with your edits, write (but do not quit) the voip_cisco_ipt_sample_dc.cfg template file.

Important: Editing the dc.cfg file is a non-trivial task and prone to error. Take your time and check your work carefully.

Netcool/Proviso Cisco IP Telephony Technology Pack User’s Guide, Version 4.3-W 449