. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Message | Possible Cause(s) | Suggested Solution(s) |
|
|
|
“The Scanner was not | Same possible causes as | Same suggested solutions as the |
found. Try the following: | the previous message. | previous message. |
Turn on Scanner Power |
|
|
|
|
Check all cables
Check for SCSI ID conflict
Verify TWAIN driver matches installed board
Check for blown fuse.”
You have several SCSI host adapters installed, and the Scanner is not connected to the host adapter selected as the TWAIN source.
Select a different TWAIN source or turn off all equipment and reconnect the Scanner to the desired host adapter.
“This driver may not be | The KODAK Driver and | Adobe Photoshop version 2.0 or |
compatible with this | your version of Adobe | higher is required. Upgrade if |
version of | Photoshop are | necessary. |
PHOTOSHOP™” | incompatible. |
|
“This driver requires 32 bit QuickDraw to operate.”
You are working with a supported Macintosh Computer but the 32 bit QuickDraw file is missing or damaged.
Install or reinstall 32 bit QuickDraw.
The KODAK Driver will not work on an older Macintosh Computer that does not have 32 bit QuickDraw.
You will not be able to use the KODAK Driver on this computer; run the driver on a different computer.
“TWAIN Error. Error opening Data Source. Failure due to unknown causes.” (Appears when attempting to access the image window with a TWAIN acquire command.)
A TWAIN compliant KODAK Driver has not been installed or has been installed improperly in the PC.
Reinstall the driver as described in Chapter 7 and try again.
