. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Message | Possible Cause(s) | Suggested Solution(s) |
|
|
|
“Firmware download failed. Check SCSI bus.”
NOTE: Firmware is downloaded automatically to the Scanner the first time that you try to access the Scanner during each work session. If this message appears, the
The Scanner SCSI ID is | Reset the Scanner SCSI ID so that |
set improperly. | it is different from other devices |
| connected to the computer. To |
| do so, turn off the computer then |
| the Scanner, set the Scanner to a |
| unique SCSI ID, turn on the |
| Scanner then the computer, and |
| try again. |
KODAK Driver is unable to download firmware to the Scanner.
You have connected the Scanner to a different computer (or to the same computer to which you recently connected an additional SCSI device), and there is now a SCSI ID conflict.
Reset the Scanner SCSI ID so that it is different from other devices connected to the computer. To do so, turn off the computer then the Scanner, set the Scanner to a unique SCSI ID, turn on the Scanner then the computer, and try again.
An unexpected problem | If the steps suggested just above |
occurred with the | do not resolve the problem, |
Scanner hardware. | reinstall the Scanner software as |
| described in Chapter 3 |
| (Macintosh) or Chapter 7 (PC), |
| and try again. |
