Kodak RFS 3570 user manual Scan the Image

. . . . . . . . . . . . . . . . . . . . . . . . . . . . .

step); if you do not select a specific portion, the entire image will be scanned. Note that IMAGE SIZE, shown below the image, changes to reflect the size of the area you selected.

NOTES: To change the size of an existing selected area, drag a handle to make the rectangle bigger or smaller.

To move the selection rectangle, place the pointer inside the rectangle, and drag the rectangle to its new location.

To deselect an area, click once inside or outside the selection rectangle.

Scan the Image

17.Click SCAN. The KODAK Driver window closes and the scan appears in a window in your software application.

NOTE: If this is the first time that you are completing a scan during this work session, or if you notice water spots or bubbles in the scanned image at any time while working with the scanner, clean the scanner “diffuser” ( a

3 x 4-inch piece of white plastic), as summarized in this note, and as fully described at the end of “Appendix C — Troubleshooting.”

A.Remove the calibration mask and single frame holder adapter or multi- frame holder.

9-22  Using KODAK Drivers with Windows Applications — PC G