Lexmark 9500 Series manual Printing photos from a digital camera using Dpof, 129

Models: 9500 Series

1 290
Download 290 pages 41.72 Kb
Page 129
Image 129

Notes:

Make sure the PictBridge-enabled digital camera is set to the correct USB mode. If the camera USB selection is incorrect, the camera will be detected as a USB storage device, or an error message will be displayed on the control panel of the printer. For more information, see the camera documentation.

The printer reads only one media device at a time.

Warning—Potential Damage: Do not touch the USB cable, any network adapter, or the printer in the area shown while actively printing from a PictBridge-enabled digital camera. A loss of data can occur. Also, do not remove the USB cable or network adapter while actively printing from a PictBridge-enabled digital camera.

SD/MMC

MS

 

XD

 

CF/MD

 

 

 

P

 

 

ictBr

 

 

idge

3 If the PictBridge connection is successful, the following message appears on the display: Camera Connected.

Refer to Camera display or Camera owners manual for further information.

After a few seconds, the following message appears: Use Camera to choose and print photos.

Press

to select printer default settings.

4To use the camera to control printing photos, see the instructions in the camera documentation.

Press on the control panel to specify the PictBridge default print settings, which are used if no selections are made on the camera.

Printing photos from a digital camera using DPOF

Digital Print Order Format (DPOF) is a feature available on some digital cameras. If your camera supports DPOF, you can specify which photos to print, how many of each, and print settings while the memory card is still in the camera. The printer recognizes these settings when you insert the memory card into the printer.

Note: If you specified a photo size while the memory card was still in the camera, make sure the size of the paper loaded in the printer is not smaller than the size you specified in the DPOF selection.

1Load photo paper in Tray 1 or in the small media feeder.

Note: Load the photo paper with the glossy or printable side facing down. (If you are not sure which side is the printable side, see the instructions that came with the paper.)

2Insert a memory card.

3From the control panel, press .

4Press or repeatedly until Print Camera Selections is highlighted.

5Press .

6Press again.

Working with photos

129

Page 129
Image 129
Lexmark 9500 Series Printing photos from a digital camera using Dpof, 129, Printer reads only one media device at a time