Lexmark 9500 Series manual Setting up the printer

Setting up the printer

The following instructions are for setting up the printer for the first time. After completing these steps, you do not need to set up the printer again if you want to use it on another computer.

Note: You must complete these steps before you set up the printer on a network.

1Unpack the printer.

Note: Place the printer near the computer during setup. If you're setting up on a wireless network, you can move the printer after setup is complete.

2Remove all tape and packing material from all areas of the printer.

3If needed, install the correct control panel for your language.

4Pull the paper tray completely out of the printer.

5Move the paper guides to the sides.

6Load paper.

7Adjust the paper guides.

8Insert the paper tray.

9Connect the power cord to the printer and then to a properly grounded electrical outlet.

Note: Do not attach the USB cable yet.

10Make sure the power is on.

11Set the language and country/region.

aPress or repeatedly until the language you want appears on the display.

bPress .

cPress or repeatedly until the country/region you want appears on the display.

dPress .

12Set the date and time.

aUse the keypad to enter the time, and press or to scroll between the hours and minutes.

bPress or to scroll to AM, PM, or 24HR, and press or to change the setting.

cPress .

dUse the keypad to enter the date, and press or to scroll between day, month, and year.

ePress .

13Set the fax name and fax number, if needed. a Use the keypad to enter the fax number.

bPress .

cUse the keypad to enter the fax name.

dPress .

14Open the printer.

15Press down on the cartridge carrier levers.

Connecting the printer to a network

53