Muratec MFX-C3035 manual Envelope, Do not use envelopes that have

Envelope

Print on the front (address) side only. Some parts of the envelope consist of three layers of paper—the front, back, and flap. Anything printed in these lay- ered regions may be lost or faded.

You can print continuously with envelope. However, this could affect the media feed, depending on the media quality and printing environment. If problems occur, stop the continuous printing and print one sheet at a time.

Capacity	Tray 1	Up to 10 sheets, depending on their thick-
		ness
	Tray 2/3/4	Not supported
Orientation	Face down
Driver	Envelope
Media Type
Duplexing	Not supported

Use envelopes that are

„Common office envelopes approved for laser printing with diagonal joints, sharp folds and edges, and ordinary gummed flaps

" Because the envelopes pass through heated rollers, the gummed area on the flaps may seal. Using envelopes with emulsion-based glue avoids this problem.

„Approved for laser printing

„Dry

DO NOT use envelopes that have

„Sticky flaps

„Tape seals, metal clasps, paper clips, fasteners, or peel-off strips for seal- ing

„Transparent windows

„Too rough of a surface

„Material that will melt, vaporize, offset, discolor, or emit dangerous fumes

„Been presealed

4-6 Print Media