Muratec MFX-C3035 Quality Mode / Speed Mode, Settings. If it becomes necessary to, Representative

	[AIDC Mode]		Settings	[Mode 1] / [Mode 2]
			Select the AIDC operation mode.
			[Mode 1]: Standard mode
			[Mode 2]: Low mode
	[Thick Mode]		Settings	[Quality Mode] / [Speed Mode]
			In order to prevent toner from clogging within
			the developer unit as a result of it being driven
			at half-speed, select the timing for driving the
			developer unit at full speed for a fixed length of
			time when thick paper is being fed.
			[Quality Mode]: While printing on thick paper,
			printing is periodically paused, and the devel-
			oper unit is driven at full speed for a fixed
			length of time. Since printing is paused, the
			quality is not affected; however, a standby time
			of approximately 70 seconds occurs every 400
			seconds or so of half-speed operation.
			[Speed Mode]: While printing on thick paper,
			only the drive of the developer unit periodically
			switches to full speed for a fixed length of time.
			Since printing continues during full-speed
			drive, the print quality is slightly affected, how-
			ever the standby time is short.
	[Engine DipSW]		Change the DIP switches to control machine
			operation.
		[Engine DipSW 1] -	Settings	[ON] / [OFF]
		[Engine DipSW 28]
			Use to change engine settings.
			" Normally, there is no need to change the
			settings. If it becomes necessary to
			change the settings, do so according to
			the instructions from the service
			representative.
[Main Scan Adjust]			Adjust the scanning settings.
	[Main Scan Page]		Settings	[Print] / [Cancel]
			Print the test pattern for fine adjustment of the
			color ratios in the main scanning direction.

3-68 [Admin Settings]