Nortel Networks DCT1900 manual Base Station Mounting Indoor 16.6.1 Wall Mount, Ceiling Mount

Technical Product Manual - DCT1900

Installation Instructions, Base Station – KRC 101 1371

RJ45 modular jack

EPP1 EPP0 SC1-0 SC0-0 SC0-1 SC1-1 NC NC

Pin 1 = EPP1 - green/white Pin 2 = EPP0 - white/green

Pin 3 = SC1-0 - white/blue Pin 4 = SC0-0 - white/orange Pin 5 = SC0-1 - orange/white Pin 6 = SC1-1 - blue/white

SC=Serial Channel

EPP=Express Power Pair

NC=Not Connected

Fig. 16–2 Connector Pinning

Note:

After completion of the installation, Base Stations must be added using the CSMW “Installer Quick Guide”.

16.6Base Station Mounting - Indoor 16.6.1 Wall Mount

The Base Station comes with its own Base Station mounting bracket. The necessary antenna are ordered and shipped separately. The Base Station is to be mounted such that when wall mounted the top of the antenna is at least 6 inches below the ceiling. If the ceiling is made of metal or contains a metal plate, the distance between the metal plate and the antenna must be at least one foot.

Once the location where the Base Station is to be mounted has been determined, take the mounting plate (see Fig. 16-1, Base Station Cover and Back) and spot it where the Base Station is to be mounted.

1.Mark the location for the mounting hardware.

2.Secure the rear bracket to the wall. Use #6 mounting hardware. The side of the bracket with the part no. SXANB 101 127/X goes towards the wall.

3.Plug the Base Station cable into either one of the RJ45 jacks on the back of the Base Station.

4.Place the Base Station over the rear plate on the wall and slide it down until the Base Station locks in place onto the rear bracket.

5.Connect the antenna to the Base Station, then slide the rubber grommet supplied with the antenna kit down over the antennas until they are firmly seated in the Base Station itself.

16.6.2Ceiling Mount

A kit, part number NTM 201 1754 is provided for the ceiling mounting of base stations. Ine kit is required for each ceiling mounted base station. Teh following instructions, also the kit are included for reference.

Instructions - Ceiling Mount Kit

1.Cut out center portion of mounting clip to make room for ceiling clip threads.

Install-DCT1900/R8/mw	16-7
© 2000-2005