Technical Product Manual - DCT1900

Installation Instructions, Modular Cabinet – Cables

CHAPTER 26

Modular Cabinet – Cables

This chapter gives an overview of the cables used in a system with Modular Cabinets. The main purpose of this overview is to enable cable repair if necessary.

26.1Mains Power Cord - RPM 113 3563

26.2Power Cable Filter/Switch – TRENB 101 02

The power cable filter/switch (see Figure 26–1) is a 2–wire 2.5mm2 cable with two connectors on both sides. It is used to supply power from the filter to lower fuse holders in the Modular Cabinet. This cable does not need to be ordered separately. It is factory connected to the switch.

K1

K3

K4

K2

7.9 in

CapFaston

Fig. 26–1 Power Cable Filter/Switch – TRENB 101 02

Install-DCT1900/R8/mw

26-1

© 2000-2005

 

Page 305
Image 305
Nortel Networks DCT1900 manual Modular Cabinet Cables, Mains Power Cord RPM 113 Power Cable Filter/Switch Trenb 101