Setting Conditions for Communications with Host by Using Memory Switches

Section 6-7

6-7-4 Setting the NT Link (1:N) Method (Standard/High-speed)

Set the communications conditions for the NT Link (1:N) method at serial port A or serial port B by following the operation from the System Menu shown below.

The communications speed determines whether the 1:N NT Link is standard or high-speed.

Standard: Standard 1:N NT Link

High-speed: High-speed 1:N NT Link

Ver 4.12

Select Maintenance Mode.

 

Select Memory Switch.

Display the fourth memory switch screen by pressing the [] (next screen) or [] (previous screen) touch switch.

Press the touch switch corresponding to the port at which the NT Link (1:N) method (standard or high-speed) is to be set (Comm. A Method or Comm. B Method) to display the setting option NT Link (1:N).

The setting option changes each time the touch switch is pressed.

In this example, serial port A is used.

158

Page 175
Image 175
Omron NT631C manual Setting the NT Link 1N Method Standard/High-speed, Select Maintenance Mode