Omron NT631C manual Fitting The Touch Panel Cable

Maintenance of the NT631/NT631C Section 7-3

Removing and Fitting The Touch Panel Cable

Removing The Touch Panel Cable:

Pull the arrow-marked sections up to the cable side to unlock the connector, and remove the cable.

Fitting The Touch Panel Cable:

While unlocking the connector, insert the touch panel cable fully. Then, lock the connector.

Locked	Unlocked	Not locked
		completely

5.Loosen two mounting screws, and remove the backlight.

When loosening or tightening screws for backlights, be sure to use a mag- netized Phillips screwdriver. If any screw falls inside the Unit, it must be ex- tricated without fail.

6.Fit new backlights.

The backlight for the top is different from that for the bottom.

Each backlight has three projections. Slot these projections into slits on the Unit, and tighten the screws while lightly holding the backlight by fingers. Make sure that the cable does not come out of the backlight. If it comes out, put it in the backlight and then tighten the screws.

The tightening torque must be 0.2 N·m.

237