Omron NT631C manual CQM1, CQM1H, C200HX, HG/HE-ZE, or SRM1, CPM1 or CPM2A, CS/CJ-series PLC

Programming Console Function Section 6-12

CQM1: @@@3, @@@4, @@@5, @@*6

where * is a number in the range 1 to 9 or the letter X or Y.

C200HX/HG/HE: @@@5 @@*6

where * is a number in the range 1 to 9 or the letter X or Y.

6-12-2 Connection Method

CQM1, CQM1H, C200HX/	The connection method is exactly the same as for the NT Link (1:1). Refer to
HG/HE(-Z)E, or SRM1	SECTION 4 Connecting to the Host from the RS-232C Port or SECTION 5
	Connecting to the Host from the RS-422A/485 Port for details on connecting
	to the PLC.
	* When using the Programming Console function with a CQM1H, turn ON pin
	7 of the DIP switch on the front of the CQM1H’s CPU Unit.
CPM1 or CPM2A	The connection method is the same as for the NT Link (1:1). With a CPM1,
	connect the RS-232C cable to the peripheral port via a CPM1-CIF01 RS-
	232C Adapter or CPM1-CIF11RS-422A Adapter.
	Refer to SECTION 4 Connecting to the Host from the RS-232C Port or SEC-
	TION 5 Connecting to the Host from the RS-422A/485 Port for details on con-
	necting to the PLC.
CPM2C	The connection method is the same as for the NT Link (1:1). Connect to the
	PLC’s communications connector with a CPM2C-CN111 or CS1W-CN114/
	118 Connecting Cable, a CPM1-CIF01RS-232C Adapter, or a CPM1-CIF11
	RS-422A Adapter.
	Refer to SECTION 4 Connecting to the Host from the RS-232C Port or SEC-
	TION 5 Connecting to the Host from the RS-422A/485 Port for details on con-
	necting to the PLC.
	* When using the Programming Console function with a CPM2C, turn ON pin
	2 of the DIP switch on the front of the CPM2C’s CPU Unit.
CS/CJ-series PLC	The connection method is exactly the same as for the NT Link (1:N) (standard
	or high-speed). Refer to SECTION 4 Connecting to the Host from the RS-
	232C Port or SECTION 5 Connecting to the Host from the RS-422A/485 Port
	for details on connecting to the PLC. The standard or high-speed 1:N NT Link
	can be used.
	The Programming Console function can be used only when the PT’s unit num-
	ber is set to 0. Only one Unit using the Programming Console function can be
	connected to each of the PLC’s ports (built-in RS-232C port and peripheral
	port).
	Make sure that the PT’s highest unit number is set to 0 in the CS/CJ-series
	PLC setup.
	With the CS/CJ-series PLC, the Programming Console function can not be
	used simultaneously at both the built-in RS-232C port and peripheral port.
	Furthermore, the Programming Console function can not be started at the
	RS-232C port while a Programming Console is connected to the peripheral
	port.

216