System Menu Operation Flow

Section 6-1

6-1 System Menu Operation Flow

Create the Screen Data

Start Up the NT631/

NT631C (Display the

System Menu) (page 129)

Initialize the Memory (page 135)

Transmit the Screen Data (page 149)

Set the Memory Switches (pages 152, 164, 184)

Start Operation (page 163)

System Maintenance (page 187)

Follow the procedure below when using the NT631/NT631C for the first time or changing the system program.

Create the data to be displayed on the NT631/NT631C by using the Support Tool.

For details on creating screen data, refer to the NT-series Support Tool Ver. 4.@ for Windows Operation Manual (V061-E1-@).

Turn ON the power to the NT631/NT631C.

If no screen data has been registered, an error message is displayed. In this case, press the OK touch switch on the error message screen to display the System Menu.

If screen data has been registered and the RUN mode is established, perform the appropriate operations on the touch panel to display the System Menu.

If necessary, initialize the memory of the NT631/NT631C by operation from the System Menu.

Connect the Support Tool to the NT631/NT631C and transmit the screen data from the Support Tool to the NT631/NT631C.

For details on connecting the Support Tool, refer to 3-2 Connecting to the Support Tool (page 35).

Select the System Menu and set the operations of the NT631/NT631C — for example the conditions for communications with the host — using the mem- ory switches.

Connect the NT631/NT631C to the host and start operation.

If an error occurs during operation, check the I/Os, settings, etc., by referring to this guide.

6-2

Starting the NT631/NT631C

 

 

 

After checking that the hardware has been connected correctly, switch on the

 

 

 

power to the NT631/NT631C to start it up.

 

 

 

This section describes the operation of the NT631/NT631C when it is started

 

 

 

up.

6-2-1

Operation at Startup

 

 

 

The NT631/NT631C operates as follows when the power is switched ON, or

 

 

 

when it is reset.

Initial Processing

Self diagnosis — including a check on the internal memory of the NT631/

 

 

 

NT631C and a system program check — and the internal processing required

 

 

 

 

 

 

for startup, are performed.

 

 

 

If an error occurs during initial processing, an error screen is displayed.

 

 

 

If there is an error in the system program, the system program must be re-

 

 

 

installed. For details on the installation procedure, refer to 6-5 Operations in

 

 

 

the System Installer Mode.

129

Page 146
Image 146
Omron manual System Menu Operation Flow, Starting the NT631/NT631C, Operation at Startup, Initial Processing