Omron NT631C manual Relationship between system program Hardware, Model History System program

Appendix I

Relationship between system program and

hardware

Here, relationship between system program and hardware is described.

System programs indicated below are installed for the models shown above in the default state. Also, system programs are supplied with the Support Tool as follows.

Model	History	System program
NT631-ST211@-E	Conventional product	System Program version 1.@	Same for pre-version-1 and
			version-2 hardware, but
NT631C-ST141@-E		(supplied with the
			there are restrictions to
		NT-ZJCMX1-EV2)
NT631C-ST151@-E
			some functions depending
NT631-ST211@-EV1	Version upgrade of the	System Program version	on the hardware version that
	above products	2.0@ or 2.1@	is installed.
NT631C-ST141@-EV1
	(December 1998)	(supplied with the
NT631C-ST151@-EV1
		NT-ZJCMX1-EV3)
NT631-ST211@-EV2	Version upgrade of the	System Program version
	above products	3.0@ or 3.1@
NT631C-ST141@-EV2
	(December 1999)	(supplied with the
NT631C-ST151@-EV2
		NT-ZJCMX1-V4.00)
NT631C-ST152@-EV2	Version upgrade of the	System Program version
	above products	3.1@
	(October 2004)	(supplied with the
		NT-ZJCMX1-V4.05)
NT631C-ST153@-EV3	Version upgrade of the	System Program version	Only for hardware for ver-
	above products	4.1@	sion-3 (EV3) PTs. Cannot be
	(September 2006)	(supplied with the	installed with pre-version-1
			or version-2 hardware.
		NT-ZJCMX1-V4.08)

Note NT System Installer version 2.0 or higher is required to transfer the NT631-EV3-compatible system pro- gram. (NT System Installer version 2.0 is provided with the NT-series Support Tool version 4.08 or higher.)

These system programs have mutual compatibility, therefore, they can be installed and used for NT631- ST211@-E/NT631C-ST141-E/NT631C-ST151@-E, NT631-ST211@-EV1/NT631C-ST141@-EV1/NT631C- ST151@-EV1, and NT631-ST211@-EV2/NT631C-ST141@-EV2/NT631C-ST151@-EV2/NT631C-ST152@-EV2 each.

However, there will be a limitation on function depending on the combination. Refer to the following table.

System program version 4.0@ is only for NT631C-ST153@-EV3. The system program cannot be installed in pre-version-2 hardware. System program earlier than Ver. 3.1@ cannot be installed in NT631C-ST153@-EV3.

The following table shows only the relationship between the hardware and system program.

For details of the relationship with the screen data created using the Support Tool, refer to NT-series Support Tool for Windows (Ver. 4.@) Operation Manual (V061-E1-@).

277