Q-Logic MKII-BASE16 user manual Gbic

GBIC

GBIC

GBICs may be removed and replaced with the power on and the Switch operating without disrupting traffic on other ports.

Removal

1.Disconnect the cable (if one is connected) from the GBIC you are removing.

2a. Removing GBICs that have individually operated latches. See Step 2b for GBICs with bails.

The typical GBIC is represented in the drawing below. You must press both latches in order to remove the GBIC.

Using the thumb and forefinger of one hand, grasp the GBIC Latches and squeeze them toward the center of the GBIC. While squeezing, withdraw the GBIC from the chassis.

When the GBIC is withdrawn, a small spring-loaded door will close the opening.

Note: The force required to overcome the friction of the pins in the GBIC connector and withdraw it from the chassis may be more than you can exert without your fingers slipping off the latches. If you have trouble, try a piece of double-backed tape under your thumb and forefinger to get a better grip on the GBIC. Do not use pliers or similar tools. You may damage the GBIC.

GBIC

GBIC Latches (one on each side)

GigWorks MKII-16 Switch Model MKII-BASE16		Removal/Replacement Procedures 5-3
Installer's/User's Manual	59003-01 Rev. A