Q-Logic MKII-BASE16 user manual Operating the Switch

Installation

Operating the Switch

The Continuous Test button on the front of the Switch chassis and the switches on the Chassis Switch Panel on the back of the Switch chassis are the only operational controls. Place the Continuous Test button in the IN position for normal operation. The Test mode switches must be set to 0 (POST). Refer to the Chassis Switch Panel paragraphs in Section 1 of this manual. The default is 0.

The Switch becomes operational when:

•it is connected to an operational power source,

•the Power Button is in the ON (In) position,

•the Continuous Test button is in the OP (In) position,

•the Test Mode Switches are set to 0 (POST),

•and two or more Fibre Channel F or FL_Ports are cabled to their respective operational N or NL_Ports respectively.

2-12Installation	GigWorks MKII-16 Switch Model MKII-BASE16
	59003-01 Rev. A	Installer's/User's Manual