Q-Logic MKII-BASE16 Switch Utilities Setup, Ethernet Port Radio Button, Ethernet IP Address Box

Switch Utilities — Setup

Setup

Figure 3-7 Setup Tab

Refer to Figure 3-7. The Setup tab enables you to set up the connection between the Ethernet port on the PC and the Ethernet port on the Switch and to track the communication that takes place over this connection.

The Setup tab also enables you to read and display UART statistics.

Ethernet Port Radio Button

The Ethernet Port Radio Button, when selected, causes the Utilities to communicate to the Switch through the Ethernet port on the PC.

Ethernet IP Address Box

This is the IP Address that the Utilities application uses to communicate with the Switch. The IP Address set in the Switch at the factory is 10.0.0.1. Therefore, the first time you use the Utilities you must use this address. You may change the Switch IP Address using the Mmanagement. Configuration Tab.

To change the IP Address that the Utilities application uses to communicate with the Switch, select the IP Address and type the new address.

GigWorks MkII-16 Switch Model MKII-BASE16		Switch Management 3-21
Installer's/User's Manual	59003-01 Rev. A