Ricoh 2400L manual

34

1. Function 6 2 2 2 2 6 3 and Yes.

At this time, you can print a User Pa- rameter List if you press jand Start.

Changing the Stamp Home Position Setting

If you wish to change the Stamp default setting, doSETTING?PRINTthe following.LISTj Y/j

(See page 168 if you need more information about the User Parameter settings adjustment procedure).

4. Finish: Yes and Function.

Using the Stamp

Press the Stamp key to achieve the transmission verification stamp. When the Stamp indicator is lit, the machine stamps a small mark on the bottom of each page. During memory transmission, the stamp indicates that the page was successfully stored. For immediate transmission, it shows that the page was sent successfully. You must switch the stamp on before you press Start, or the machine will not stamp the first page.

Digit 6 (Double underlined) 0: Memory Transmission

1: Immediate Transmission

2. Press Yes.The settings for switch 00 are now shown on the bottom line of the dis- play.

The setting that you need to change is that for digit 6.

3. If you wish to change the setting, press 6 on the ten keypad.

❐ At this time, you can print a User Parameter List if you press jand Start.

1. Function 6 2 2 2 2 6 3 and Yes.

The default mode of your machine is Memory TransmissionSETTING?SWITCH. If you wish, youY/jcan change this home position to Immediate Transmission. KPAD/Y/jk

The procedure is as follows (see page 168 if you need more00:00000000information about the User Parameter settings adjustment procedure).

SWITCHPRNTLIST00j:00000000

Immediate Transmission as Your First Choice

ROUTINE OPERATION

SENDING A FAX MESSAGE