Ricoh 2400L manual Default settings

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

Digit 0 (Underlined)

Digit 1 (Double Underlined)

1. Function 6 2 2 2 2 6 3 and Yes.

At this time, you can print a User Pa- rameter List if you press ￿ and Start.

2. The settings for switch 00 are now shown on the bottom line of the display.

Cross-reference:ECM: see page 77.

ROUTINE OPERATION RECEIVING FAX MESSAGES

Switching Substitute Reception On or Off

There are two conditions under which you may wish to disable this feature. ❐ If you do not like keeping received fax messages in memory: After your

machine has received a fax message to memory, it sends an OK signal to the other end. However, if something happens to your machine and you lose the fax message before you have a chance to read it, the sender will not be informed. Therefore, you may not wish to use the Substitute Reception feature.

❐ If you do not wish to have your memory full of mail from unknown senders: If

you have not enabled the Authorized Reception feature, you can receive fax messages from anybody. However, you can see who they are because their identifier (the TTI) is printed at the top of each page. If the other party has not programmed their identifiers (perhaps in an attempt to hide their identity), you may not wish to receive their messages into memory, which would take up valuable space.

Authorized￿￿￿￿￿Reception:￿￿￿￿see page 89. ￿￿￿

If you wish to switch Substitute Reception on or off, do the following procedure. (See page 184 if you need more information about the User Parameter settings adjustment procedure).

￿￿￿￿￿

￿￿￿￿￿￿￿￿ ￿￿￿￿

3. Press ￿ until the settings for switch 05 are shown.

The settings that you need to change are those for digits 0 and 1.

The meanings of these settings are as follows.

ROUTINE OPERATION

Digit		Purpose
0	Substitute Reception	0: Off	1: On*
	Reception to memory (including Substitute Reception, Memory Lock and
1	Forwarding from another station) when no RTI or CSI identifiers were received from
	the other party	0: Enabled*	1: Disabled

*Default settings

4.If you wish to change the setting, press 0 or 1 of the ten key pad.

5.Finish: Yes and Function.

45