Ricoh 551, 700 manual When Copying onto OHP Transparencies or Thick Paper, Press the OK key

Copying

Note

❒If you do not register the non-standard size, go to step F.

❒Only one non-standard size can be stored.

❒To recall the non-standard size stored, press the [Recall] key.

❒If you do not register the non-standard size, the size you set is deleted when modes are cleared.

2 F Press the [OK] key.

DSet your originals, then press the {Start} key.

EWhen your copy job is finished, press the {Clear Modes/Energy Saver} key to clear the settings.

When Copying onto OHP Transparencies or Thick Paper

To make copies onto OHP transparencies or thick paper, you need to specify the paper type.

Limitation

❒When you select “OHP” or “Thick Paper”, copy paper is delivered face up

even if you have set the “Face-Up/Down Selection in Bypass Mode” setting to “Face Down Exit”. See “Face-Up/Down Selection in Bypass Mode” in ⇒ P.331 “Count Manager”.

Note

❒Select [Thick Paper] if the paper weight is more than 105g/m2, 28 lb. Bond.

AOpen the bypass tray, and adjust the guides to the paper size.

Important

❒If the guides are not flush with the copy paper, a skew image or paper mis- feeds might occur.

BLightly insert the OHP transparencies or thick paper face up until the beep- er sounds.

The k indicator on the display automatically goes on.

Note

❒When you set an OHP transparency, make sure that its front and back faces are properly positioned.

❒To avoid paper misfeeds, fan the paper before setting it in the tray.

CPress the {#} key.

76