Ricoh 700, 551 manual To interrupt an original being fed, Press the Interrupt key

Other Functions

❒In Connect Copy mode, you cannot use the Interrupt Copy function when memory on the sub-unit is full.

❒In Connect Copy mode, after finishing the interrupt copy job on the sub-unit, be sure to exit Interrupt mode on the sub-unit. When you exit Interrupt mode, the two machines automatically share the rest of the connect copy job.

❒In Connect Copy mode, if the connect copy job is finished before finishing the

interrupt copy job on the sub-unit, be sure to exit Interrupt mode on the sub-

unit. If you do not exit Interrupt mode, the next connect copy job cannot be 2 started.

To interrupt an original being fed

APress the {Interrupt} key.

The Interrupt indicator goes on and scanning stops.

BRemove the originals that were being copied and set the originals you wish to copy.

CPress the {Start} key.

The machine starts making your copies.

DWhen your copy job is finished, remove your originals and copies.

EPress the {Interrupt} key again. The Interrupt indicator goes off.

FWhen the display prompts you to, replace the originals that were being copied before.

GPress the {Start} key.

The previous copy job settings will be restored and the machine will continue copying from where it left off.

To interrupt copying after all originals have been fed

APress the {Interrupt} key.

The Interrupt indicator goes on.

Note

❒ Copying will not stop yet.

BSet your original.

CPress the {Start} key.

The machine stops the original job and starts copying your original.

89