TANDBERG D14049.01 manual Far end were registered directly to the local system, Fallback Alias S 0

CommandText goes hereReference - xConfiguration

TANDBERG VIDEO COMMUNICATION SERVER ADMINISTRATOR GUIDE

Call	Services	CallsToUnknownIPAddresses: <Off/Direct/Indirect>
		Determines the way in which the VCS will attempt to call systems which are not registered with it or one of its neighbors.
		Direct: Allows an endpoint to make a call to an unknown IP address without the VCS querying any neighbors. The call setup would occur just as it would if the
		far end were registered directly to the local system.
		Indirect: Upon receiving a call to an unknown IP address, the VCS will query its neighbors for the remote address, relying on the response from the neighbor to
		allow the ability for the call to be completed; connecting through the routing rules as it would through the neighbor relationship.
		Off: This will not allow any endpoint registered directly to the VCS to call an IP address of any system not also registered directly to that VCS.
		Fallback Alias: <S: 0, 60>
		Specifies the alias to which incoming calls are placed for calls where the IP address or domain name of the VCS has been given but no callee alias has been
		specified.
Ethernet	Speed: <Auto/10half/10full/100half/100full/1000full/None>
	Sets the speed of the Ethernet link.
	Auto: the VCS will automatically determine the speed to be used.
	10half: a speed of 10half will be used.
	10full: a speed of 10full will be used.
	100half: a speed of 100half will be used.
	100full: a speed of 100full will be used.
	1000full: a speed of 1000full will be used.
	None: the VCS will automatically determine the speed to be used.
	Note: You must restart the system for any changes to take effect.
ExternalManager	Address: <S: 0, 128>
	Sets the IP address or FQDN of the External Manager.
	Path: <S: 0, 255>
	Sets the URL of the External Manager.
H323	Gatekeeper	AutoDiscovery	Mode: <On/Off>
			Determines whether or not the VCS responds to gatekeeper discovery requests from endpoints.
			On: the VCS will respond to requests.
			Off: the VCS will not respond to requests.
		CallSignaling	PortRange	Start: <1024..65534>
				Specifies the lower port in the range to be used by calls once they are established.

End: <1024..65534>

Specifies the upper port in the rage to be used by calls once they are established.

Introduction	Getting	System	System	H.323 & SIP	Registration	Zones and	Call	Firewall	Bandwidth	Maintenance	Appendices
	Started	Overview	Configuration	Configuration	Control	Neighbors	Processing	Traversal	Control
D 14049.01					132
07.2007