TANDBERG D14049.01 manual Ntp

CommandText goes hereReference - xConfiguration

TANDBERG VIDEO COMMUNICATION SERVER ADMINISTRATOR GUIDE

IP	SubnetMask: <IPAddr>
cont...	Specifies the IPv4 subnet mask of the VCS. Note: You must restart the system for any changes to take effect.
	V6	Address: <S: 0, 39>
		Specifies the IPv6 address of the VCS. Note: You must restart the system for any changes to take effect.

Gateway: <S: 0, 39>

Specifies the IPv6 gateway of the VCS. Note: You must restart the system for any changes to take effect.

IPProtocol: <Both/IPv4/IPv6>

Selects the IP protocol(s) supported by the VCS.

Both: the VCS will support both IPv4 and IPv6.

IPv4: the VCS will support IPv4 only.

IPv6: the VCS will support IPv6 only.

Note: You must restart the system for any changes to take effect.

LDAP	Encryption: <Off/TLS>
	Sets the encryption to be used for the connection to the LDAP server.
	Off: no encryption is used.
	TLS: TLS encryption is used.
	Password: <S: 0, 128>
	Sets the password to be used when binding to the LDAP server.

Log

NTP

Introduction

D 14049.01

07.2007

Server	Address: <S: 0, 128>
	Sets the IP address or FQDN of the LDAP server to be used when making LDAP queries.
	Port: <1..65534>
	Sets the IP port of the LDAP server to be used when making LDAP queries.

UserDN: <S: 0, 255>

Sets the user distinguished name to be used when binding to the LDAP server.

Level: <1..3>

Controls the granularity of event logging. 1 is the least verbose, 3 the most.

Server

Address: <S: 0, 128>

Specifies the IP address or FQDN of the server to which the log will be written.

Address: <S: 0, 128>

Sets the IP address or FQDN of the NTP server to be used when synchronizing system time.

Getting

System

System

H.323 &

SIP

Registration

Zones and

Call

Firewall

Bandwidth

Maintenance

Appendices

Started

Overview

Configuration

Configuration

Control

Neighbors

Processing

Traversal

Control

134