TANDBERG D14049.01 manual Zones LocalZone Traversal H323 Cont, RetryCount, RetryInterval

CommandText goes hereReference - xConfiguration

TANDBERG VIDEO COMMUNICATION SERVER ADMINISTRATOR GUIDE

Zones	LocalZone	Traversal	H323
cont...	cont...	cont...	cont...

Introduction	Getting	System	System	H.323 & SIP
	Started	Overview	Configuration	Configuration

D 14049.01

07.2007

Preference: <Assent/H46018>

If an endpoint that is registered directly with the VCS supports both Assent and H.460.18 protocols, this setting determines which the VCS uses.

Assent: the Assent protocol will be used.

H46018: the H.460.18 protocol will be used.

TCPProbe	KeepAliveInterval: <1..65534>
	Sets the interval (in seconds) with which a traversal-enabled endpoint registered
	directly with the VCS will send a TCP probe to the VCS once a call is established, in
	order to keep the firewall’s NAT bindings open.
	RetryCount: <1..65534>
	Sets the number of times traversal-enabled endpoints registered directly with the
	VCS will attempt to send a TCP probe to the VCS.
	RetryInterval: <1..65534>
	Sets the frequency (in seconds ) with which traversal-enabled endpoints registered
	directly with the VCS will send a TCP probe to the VCS.
UDPProbe	KeepAliveInterval: <1..65534>
	Sets the interval (in seconds) with which a traversal-enabled endpoint registered
	directly with the VCS will send a UDP probe to the VCS once a call is established,
	in order to keep the firewall’s NAT bindings open.
	RetryCount: <1..65534>
	Sets the number of times traversal-enabled endpoints registered directly with the
	VCS will attempt to send a UDP probe to the VCS.
	RetryInterval: <1..65534>
	Sets the frequency (in seconds ) with which traversal-enabled endpoints registered
	directly with the VCS will send a UDP probe to the VCS.

Registration	Zones and	Call	Firewall	Bandwidth	Maintenance	Appendices
Control	Neighbors	Processing	Traversal	Control

143