Systemtext Configuration

TANDBERG VIDEO COMMUNICATION SERVER ADMINISTRATOR GUIDE

Configuring IP Settings

To configure the VCS’s IP settings:

System Configuration > IP.

You will be taken to the IP page.

xConfiguration IP

xConfiguration IPProtocol

The VCS is shipped with a default

IP address of 192.168.0.100. This allows you to connect the VCS to your

network and access it via the default address so that you can configure it remotely.

About IPv4 to IPv6 Gatewaying

The VCS can act as a gateway between IPv4 and IPv6 calls.

To configure the VCS to act as a gateway between the two protocols, select an IP Protocol of Both.

Calls for which the VCS is acting as an IPv4 to IPv6 gateway count as traversal calls for the purposes of licensing.

Some endpoints support both IPv4 and

IPv6, however an endpoint can use only one protocol when registering with

the VCS. Which protocol it uses will be determined by the format used to specify the IP address of the VCS on the endpoint. Once the endpoint has registered using one protocol, calls to it from an endpoint using the other protocol will be gatewayed by the VCS.

Getting System

Introduction Started Overview

D 14049.01

07.2007

IP Configuration

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Save

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Restart

 

IPv6 gateway

 

 

Click here to save your

Click here to restart the

Specifies the IPv6 gateway

changes.

 

 

system.

 

of the system.

 

 

System

 

 

 

 

 

 

 

 

 

 

 

 

 

 

H.323 &

SIP

Registration

Zones and

 

 

Call

Firewall

Configuration

 

 

Configuration

 

Control

Neighbors

 

Processing

Traversal

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

21

IP protocol

You can configure the VCS to use IPv4, IPv6 or Both protocols. The default is Both.

IPv4: The VCS will only accept registrations from endpoints using an IPv4 address, and will only take calls between two endpoints communicating via IPv4. It will communicate with other systems via IPv4 only.

IPv6: The VCS will only accept registrations from endpoints using an IPv6 address, and will only take calls between two endpoints communicating via IPv6. It will communicate with other systems via IPv6 only.

Both: The VCS will accept registrations from endpoints using either an IPv4 or IPv6 address, and will take calls using either protocol. If a call is between an IPv4-only and an IPv6-only endpoint, the VCS will act as an IPv4 to IPv6 gateway. It can communicate with other systems via either protocol.

IPv4 address

Specifies the IPv4 address of the system.

IPv4 subnet mask

Specifies the IPv4 subnet mask of the system.

IPv4 gateway

Specifies the IPv4 gateway of the system.

IPv6 address

Specifies the IPv6 address of the system.

You must save your changes and restart the system for changes to take effect.

Bandwidth

Control Maintenance Appendices

Page 21
Image 21
TANDBERG D14049.01 manual Configuring IP Settings, About IPv4 to IPv6 Gatewaying, IP Configuration