Part VI | Sound |
EQUALIZER LOW:
Sound quality correction in the low range. Select EQUALIZER LOW FC; use the buttons below the display to set the standard fre- quency. Select EQUALIZER LOW GAIN; use the buttons below the display to set the ratio of change.
<PAGE 5>
KEY SHIFT:
Select KEY SHIFT. Use the buttons below the display to adjust the shift width of the output pitch of each part (in semitone increments;
MIDI CHANNEL:
Select MIDI CHANNEL. Use the balance but- tons below the display to set the MIDI channel for each part (OFF,
•Information about MIDI channels can be found on page 127.
VIBRATO RATE:
Select VIBRATO RATE. Use the buttons below the display to adjust the vibrato speed for each part (0 to 127).
VIBRATO DEPTH:
Select VIBRATO DEPTH. Use the buttons below the display to adjust the vibrato depth for each part (0 to 127).
VIBRATO DELAY:
Select VIBRATO DELAY. Use the buttons below the display to specify the time interval from when the keys are played until the vibrato starts for each part (0 to 127).
FILTER RESONANCE:
Select FILTER RESONANCE. Use the but- tons below the display to set the amount of resonance applied to each part (0 to 127).
<PAGE 2>
Sound
LOCAL CONTROL:
Select LOCAL CONTROL. Use the balance buttons below the display to turn LOCAL CONTROL ON or OFF for each part.
■EDIT MIXER
If you press the EDIT MIXER button on the PAGE 5/5 display, the display changes the set- ting display to modify the sounds.
<PAGE 1>
BRIGHTNESS:
Select BRIGHTNESS. Use the buttons below the display to set the amount of brightness applied to each part (0 to 127).
ATTACK TIME:
Select ATTACK TIME. Use the buttons below the display to set the sound attack time for each part (0 to 127).
DECAY TIME:
Select DECAY TIME. Use the buttons below the display to set the sound decay time for each part (0 to 127).
RELEASE TIME:
Select RELEASE TIME. Use the buttons below the display to set the release time for each part (0 to 127).
105
