Technics SX-PR54/M Step Record,
Auto Punch Record, Punch-in measure, Correct the performance

Part III Sequencer

7.Press the REC STOP button at the point you

want to stop recording.

•Punch recording stops immediately.

•You can also begin punch-in recording by playing the keyboard.

•You can specify the punch-in/punch-out points with the Pedal. (Refer to page 120.)

AUTO PUNCH RECORD

You can also set the punch-in and punch-out points beforehand, so that recording automati- cally begins and ends at the specified points.

1.On the PUNCH RECORD display, press the

AUTO: OFF button.

• The display looks similar to the following.

4.Use the COUNT IN MEASURE ∧ and ∨ but- tons to specify the number of lead-in mea- sures you wish to have played back before the

punch-in measure.

•Set the metronome to on or off with the ON or OFF but- ton.

5.Press the EXIT button.

• The display changes to the PUNCH RECORD display.

6.Press the START/STOP button.

•Playback begins from the measure indicated by MEA- SURE on the display.

•Pertinent information, such as the FIRST MEASURE, is shown in the upper section of the display.

7.Correct the performance.

•The mode changes automatically to the recording mode at the specified FIRST measure. Begin playing at this point. The mode automatically changes back to the play- back mode at the specified LAST measure.

•To discontinue punch recording in the middle, press the CANCEL button. In this case, the recorded contents up to that point are erased.

2.Use the FIRST MEASURE ∧ and ∨ buttons to specify the number of the punch-in measure.

3.Use the LAST MEASURE ∧ and ∨ buttons to

specify the number of the punch-out measure.

•The number of the LAST measure must be higher than the number of the FIRST measure.

•The specified measure is recorded.

Step Record

STEP RECORD is simply a method of making a tune by storing the sounds note-by-note on the display. Instead of playing the keyboard directly as in the REALTIME RECORD mode, you can take your time to input each single note. This is an especially effective method for storing complicated passages that are difficult to play or when the exact timing of a part is critical.

Sequencer

Recording procedure

Record the keyboard performance and panel changes.

1.On the SEQ MENU display, use the SONG SELECT ∧ and ∨ buttons to select the song number. Then select RECORD & EDIT.

2.On the RECORD & EDIT display, select STEP RECORD.

• The display changes to the PART SELECT display.

3.Use the balance buttons below the display to specify the track for the part you are going to record (only one track can be selected at a time).

(Continued on the next page)

65

QQTG0701