Part ISounds and effects
REVERB | • The display looks similar to the following. |
|
REVERB applies a reverberation effect to the sound.
Press the REVERB button to turn it on.
REVERB
Sounds and effects
■Type and parameter settings
1.Press and hold the REVERB button for a few
seconds.
•The display changes to the following.
2.Use the ▲ and ▼ buttons to select an effect
group.
•The EFFECT MEMORY is an edited effect group.
3.Use the buttons to the right of the display to
select a type.
•If the types comprise more than one display “page,” use the PAGE buttons to switch pages.
4.Use the TOTAL DEPTH ∧ and ∨ buttons to set the depth of the effect.
•This display can also be accessed from the REVERB & EFFECT MENU display. (Refer to page 108.)
■EFFECT EDIT
Your edited effect can be stored in a memory for later recall.
•The procedure is the same as for MULTI EFFECT. (Refer to page 37.)
CHORUS
Add breadth to the sound.
2.Use the ▲ and ▼ buttons to select the name
of the effect group.
•EFFECT MEMORY is an edited effect group.
3.Use the buttons to the right of the display to select a type.
■EFFECT EDIT
Your edited effect can be stored in a memory for later recall.
•The procedure is the same as for MULTI EFFECT. (Refer to page 37.)
BRILLIANCE
The brightness of the sound can be set for each performance part.
1.Press the PROGRAM MENUS button to turn it on.
PROGRAM
MENUS
•The display will appear as follows:
2.Select BRILLIANCE.
Press the CHORUS button to turn it on.
CHORUS
| 3. Use the PART ∧ and ∨ buttons to select a |
■ Type and parameter settings | part. |
1.Press and hold the CHORUS button for a few
seconds. | 4. Use the buttons to the left of the display to |
| select the level of brightness. |
| • For some sounds, the brightness does not change. |
38
