Assembly
Follow the steps below to assemble your Technics piano. Make sure you are using the correct parts and that they are in the correct direction.
•At least 2 people are required for assembly.
•To disassemble the piano, reverse the procedure.
1.Remove the packing and take the parts out of the carton. Confirm that all the parts on the printed list are present.
List
2.The following parts are in the screw kit.
4 | |
Black screw (A) | 4 |
Black screw (B) | 4 |
Black screw (C) | 2 |
3.Affix the right and left side planks to the pedal box.
Pedal cord
(1)Use the 4
(2)Loosen the pedal cord, stowed on the inner side of the pedal box, and extend it.
4.Affix the rear panel.
•Use 2 black screws (C) and 4 black screws (B) to affix the rear panel.
(C)
(B)
5.Place the piano
body on the stand.
WARNING:
Avoid pinching your fin- gers.
Note 1
Holding the piano body at least 10 cm in from the edge, place it on the stand so that it does not fall off.
Note 2
If the piano body is placed too far to the right or left, or to the front or back, it will become unstable.
6.Secure the piano body to the stand.
Black
Screw (A)
(1)Insert 2 screws in the 2 rear screw holes on the under- side of the piano body, and turn each screw 5 or 6 times. Push the piano body forward so that the screws are fully inserted in the cutout of the metal piece on either side plank. (This enables you to easily position the piano body on the stand.)
(2)Adjust the piano body so that the right and left sides project evenly over the stand.
(3)Positioning the piano body on the stand, confirm that the 4 screws can easily be inserted.
(4)Tighten the 4 screws securely.
7.Connect the pedal cord and power cord to the terminals.
mark | PEDAL IN |
plug 
With the mark upwards, insert the plug fully.
(1)Plug the pedal cord and power cord into the terminals on the rear of the piano.
(2)Remove the backing from the clamps and affix them as shown in the figure. Secure the pedal cord to the clamps.
Confirm: After assembling, check these points.
•Are any parts left over?
→Check the assembly procedure again.
•Does the piano rattle when it is rocked?
→Make sure all the screws are securely tightened.
•Is the power cord firmly inserted?
→Check again.
•Is the plug of the pedal cord inserted as far into the con- nector terminal as it will go?
→If it is not completely inserted, the sustain and other pedal functions may not work.
■When the piano has been moved or transported, retighten the screws securely.
135
