Part VIII

Sound Edit

Filter Edit

Make major changes to the sound by eliminating specific frequency ranges.

Sound Edit

FILTER & EQUALIZER

1.On the SOUND EDIT menu, select FILTER.

The display looks similar to the following.

Use the ▲ and ▼ buttons to select a setting item and then the and buttons to specify a selection.

Select ON/OFF and use the and buttons to select ON or OFF.

2.Use the buttons to the left of the display to select a tone.

3.Select MODE and use the and buttons to select the filter mode.

LPF(6)+EQ (low-pass filter + equalizer)

Signals higher than the cut-off frequency are cut. Normal sounds are softened.

HPF(6)+EQ (high-pass filter + equalizer) Signals lower than the cut-off frequency are cut. Normal sounds are sharpened.

LPF24 (low-pass filter 24)

A stronger low-pass filter than LPF+EQ.

HPF24 (high-pass filter 24)

A stronger high-pass filter than HPF+EQ.

BPF (band-pass filter)

Cuts off signals that are not within in the area between the two specified CUTOFF frequen- cies.

For this mode, adjust the settings on the EQUAL- IZER/FILTER side as well.

THRU

No filter effect is applied.

4.Use the CUTOFF and buttons to set the frequency range which is cut by the filter.

5.Use the RESONANCE and buttons to

specify the resonance value (dB).

Resonance is effect which adds character to the sound by emphasizing the harmonic components of frequencies close to the cut-off frequency.

<Equalizer>

For LPF(6)+EQ/HPF(6)+EQ filters, the sound quality can be modified by the EQUALIZER.

RANGE

Select the setting range (HIGH or LOW).

FREQUENCY

Set the standard frequency.

GAIN

Set the level increase or decrease from the value set for FREQ (dB).

6.Repeat steps 2 to 5 for each tone, as desired.

TOUCH & KEY FOLLOW

Adjust how the filter is applied relative to touch and pitch.

1.Use the PAGE buttons to view the 2/4 display.

The display looks similar to the following.

Use the ▲ and ▼ buttons to select a setting item and then the and buttons to specify a selection.

2.Use the buttons to the left of the display to select a tone.

3.Modify how the respective filters are applied

relative to key touch.

Select TOUCH CUT OFF and use the and buttons to

specify the amount of change in the cut-off frequency. Select TOUCH CURVE and use the and buttons to

specify the curve of change. Select TOUCH RESO- NANCE and use the and buttons to specify the degree of change in the resonance value.

4.Modify how the respective filters are applied

relative to note pitch.

• Select KEY FOLLOW SLOPE and use the and but- tons to adjust the bend slope. Select KEY FOLLOW RANGE (1–3) and use the and buttons to specify the pitch range.

5.Repeat steps 2 to 4 for the other tones, as desired.

114

QQTG0701

Page 114
Image 114
Technics SX-PR54/M operating instructions Filter Edit, Filter & Equalizer, Touch & KEY Follow