Part III | Sequencer |
CYCLE PLAY
You can have specified measures played back repeatedly.
1.On the SEQUENCER PLAY display, specify “PLAY” for track numbers you wish to have played back.
2.Press the CYCLE button.
•The display looks similar to the following.
3.Use the START MEASURE ∧ and ∨ buttons to specify the beginning measure number.
•The display looks similar to the following.
2.Specify the order of songs in the medley.
•If ALL is pressed, all the files are selected, and the songs are played back in order in a medley. If ALL is pressed again, the files are deselected.
•You can use the buttons below the display to select a song to add to the song list, then press the ADD button to add it to the list. Repeat these steps to create your own list of songs to have played back. M01, M02 etc. next to the file name indicates its order in the list.
•You can delete a marked file from the medley song list by selecting it and pressing the ADD button.
•Use the LOOP button to specify ON or OFF for repeat playback of the medley.
4. Use the END MEASURE ∧ and ∨ buttons to | 3. Press the START button. |
• During medley playback, you can use the SKIP button to | |
specify the ending measure number. | skip to the next song. |
• The measure in which the END command has been |
|
stored can also be specified. |
|
Sequencer
START |
|
| END |
1 | 2 | 3 | 4 |
CYCLE END MEASURE: 4
5.Press the START/STOP button.
•Cycle playback of the specified measures begins.
•Normally the rhythm pattern is not played back.
6.To stop cycle playback, press the START/
STOP button again.
•During playback stop, if the SEQUENCER RESET (FILL IN 1) button is pressed, the SEQUENCER returns to the measure number specified in step 3. If the SEQUENCER RESET button is pressed again, the SEQUENCER returns to measure 1.
•If you press the CYCLE: ON button to turn it OFF, cycle playback is not possible.
•To return to the SEQUENCER PLAY display, press the EXIT button.
•Cycle playback can also be specified on the SEQUENCER PLAY display whenever the CYCLE: ON indication is shown.
MEDLEY
Recorded songs can be played back in a med- ley.
1.On the SEQUENCER PLAY display, press the MEDLEY button.
SEQUENCER VOLUME
When playing the keyboard along with a recorded performance, you can adjust the total volume of all the playback parts as one.
⇒Use the APC/SEQUENCER VOLUME slide control to adjust the volume.
APC/SEQUENCER
VOLUME
MAX
OFF
•Use this control to lower the volume of the recorded play- back parts when it is too loud relative to the volume of your manual performance.
•The volume of all sounds other than your manual perfor-
•At the MAX position, the volume of the playback parts correspond to their current settings; at the OFF position, the volume is 0.
•The volume can be adjusted for each part. (Refer to page 27.)
•Except during SEQUENCER playback or DIRECT PLAY of a disk, this slide control adjusts the total volume of all the automatic accompaniment parts.
•During SEQUENCER recording, the volume is automati- cally at its maximum regardless of the position of the slide control. During playback, however, lowering the slide control from the MAX position will lower the volume from its recorded level. For this reason, the slide control should normally be left in the MAX position.
62
