Part XI | MIDI |
4. Use the OCTAVE ∧ and ∨ buttons to set the | 5. Use the LOCAL ∧ and ∨ buttons to enable or |
octave shift value (−3 to 3). | disable this instrument’s sound generator. |
• Octave shift is set for transmitted data only; however the | • When set to ON, the performance from this instrument is |
transmitted and received octave shifts are linked. For | transmitted as MIDI data and also sounds from this |
example, if the transmitted octave shift is set to 1, the | instrument. When set to OFF, the performance from this |
received octave shift is automatically set to −1. | instrument is transmitted as MIDI data but does not |
| sound from this instrument. |
| 6. Repeat steps 2 to 5 for each part as desired. |
Control Messages
Enable or disable the exchange of various control data.
1.On the MIDI MENU display, select CONTROL
MESSAGES.
•The display looks similar to the following.
•The CONTROL MESSAGES display consists of 3 pages. Use the PAGE buttons to switch between pages.
2.Use the MESSAGE ▲ and ▼ buttons to select the control message.
3.Use the ON and OFF ∧ and ∨ buttons to spec- ify on or off for the control message.
ON:
Data for the control operation is exchanged. OFF:
Data for the control operation is not exchanged.
•The BANK SELECT setting is effective only when PRG. CHANGE is set to ON.
•The EFFECT & REVERB setting controls the DIGITAL EFFECT, CHORUS, MULTI and REVERB on/off.
•RPN is the general term for KEY SHIFT, TUNING, PITCH BEND RANGE and MODULATION SENSITIVITY.
4.Repeat steps 2 and 3 for each control as desired.
Realtime Messages
Enable or disable the exchange of START/STOP data (REALTIME COMMANDS), and select the CLOCK mode.
1. On the MIDI MENU display, select REALTIME | OFF: |
MESSAGES. | This data cannot be transmitted/received. |
•The display looks similar to the following.
MIDI
2.Use the buttons on the left side of the display to select a function.
3.Use the VALUE ∧ and ∨ buttons to change the setting.
REALTIME COMMANDS ON:
Rhythm and SEQUENCER start/stop, con- tinue, and song position pointer data can be transmitted/received.
CLOCK INTERNAL:
This instrument’s internal clock is used to control the performance. The clock of the connected equipment is disabled.
MIDI:
The clock of the connected equipment is used to control the performance. This instrument’s clock is disabled. (The tempo is displayed as “q = − − −”.)
•The CLOCK is set to INTERNAL when the power to this instrument is turned on.
4.Repeat steps 2 and 3 for the other function if desired.
128
