B-6 General Information
8399APXB.DOC TI-83 Intl English, Appendix B Bob Fedorisko Revised: 02/19/01 1:12 PM Printed: 02/19/01 1:41
PM Page 6 of 14
Error Type Possible Causes and Suggested Remedies
DOMAIN ¦You specified an ar
g
ument to a function or instruction
outside the valid ran
g
e. This error is not returned durin
g
g
raphin
g
. The TI.83 allows for undefined values on a
graph. See Appendix A and the appropriate chapter.
¦You attempted a lo
g
arithmic or power re
g
ression with a
LX or an exponential or power regression with a LY.
¦You attempted to compute GPrn( or GInt( with
pmt2 < pmt1.
Duplicate Name A variable you attempted to transmit cannot be transmitted
because a variable with that name already exists in the
receiving unit.
Error in Xmit ¦The TI.83 was unable to transmit an item. Check to see
that the cable is firmly connected to both units and that
the receiving unit is in receive mode.
¦You pressed É to break during transmission.
¦You attempted to perform a backup from a TI.82 to a
TI.83.
¦You attempted to transfer data
(
other than L1 throu
g
h
L6) from a TI.83 to a TI.82.
¦You attempted to transfer L1 throu
g
h L6 from a TI.83 to
a TI.82 without usin
g
5:Lists to TI82 on the LINK SEND
menu.
ILLEGAL NEST You attempted to use an invalid function in an ar
g
ument to
a function, such as seq( within expression for seq(.
INCREMENT ¦The increment in seq( is 0 or has the wron
g
si
g
n. This
error is not returned durin
g
g
raphin
g
. The TI.83 allows
for undefined values on a graph.
¦The increment in a For( loop is 0.
INVALID ¦You attempted to reference a variable or use a function
where it is not valid. For example, Yn cannot reference
Y, Xmin, @X, or TblStart.
¦You attempted to reference a variable or function that
was transferred from the TI.82 and is not valid for the
TI.83. For example, you may have transferred U
n
N1 to
the TI.83 from the TI.82 and then tried to reference it.
¦In Seq mode, you attempted to
g
raph a phase plot
without defining both equations of the phase plot.