Toshiba e-STUDIO281c, 451C, 351C manual Color to be

2. Copier-specific Adjustments

(3) Enter adjustment mode [05]. Change the values for codes [1779 to 1798] to adjust the color density.

Color to be	Original mode	[05] code	Subcode	Value recommended	Acceptable	Default
adjusted					value range
	Text/Photo	05-1779	0/1/2
Y	Text	05-1780	0/1/2
	Printed image	05-1781	0/1/2
(Yellow)
	Photo	05-1782	0/1/2
	Map	05-1783	0/1/2
	Text/Photo	05-1784	0/1/2
M	Text	05-1785	0/1/2
	Printed image	05-1786	0/1/2
(Magenta)				Set a value larger than 128
	Photo	05-1787	0/1/2
				to increase the density.
	Map	05-1788	0/1/2		0 to 255	128
	Text/Photo	05-1789	0/1/2	Set a value smaller than 128
	Text	05-1790	0/1/2
C				to decrease the density.
	Printed image	05-1791	0/1/2
(Cyan)
	Photo	05-1792	0/1/2
	Map	05-1793	0/1/2
	Text/Photo	05-1794	0/1/2
K	Text	05-1795	0/1/2
	Printed image	05-1796	0/1/2
(Black)
	Photo	05-1797	0/1/2
	Map	05-1798	0/1/2

*Set the value in increments of approximately 10, while checking the copy image until the optimum value is obtained.

*Changing the values for the codes corresponding to Text/Photo mode will affect the copy image quality in Full color mode and Auto color mode.

*The subcode varies, according to the area for which the density is adjusted. Refer to the table below and

set the subcode for the area to be adjusted.

Subcode	Area for the density to be adjusted
0	Low-density area
1	Medium-density area
2	High-density area

‰Cautions after the completion of the adjustment

The adjustment may possibly vary the hues of areas (including photo images and text) other than those marked with highlighters. Therefore, carefully perform the adjustment, while checking the copy image.

‰Remarks

Enter the value within the recommended value range mentioned in the procedures. Otherwise, it may cause a loss in copier performance, including degradation in the image quality.

e-STUDIO281c/351c/451c 2.12