MFP CONTROLLER OPTIONS August 2006
1-126
USB SP Settings
The following SP commands are available. But, only one setting can be adjusted,
and this must only be done if the customer has USB data transmission errors.
NOTE: Do not change the settings marked “DFU”. These settings are for design
and factory use only.
To go into the SP mode:
1. Press ‘Clear Modes’
2. On the operation panel keypad, input 107.
3. Hold down [Clear/Stop] () for more than 3 seconds.
4. Press “Copy SP” on the touch-panel to open the SP command selection screen.
5. Input 5844.
SP No. Name Function
Adjusts the USB transfer rate. Do not change the setting
unless there is a data transfer error with the USB high
speed mode.
HS/FS:
High speed/Full speed auto adjust
(480Mbps/12Mbps)
5844 001
Transfer Rate
FS: Full speed (12Mbps fixed)
5844 002
Vendor ID Displays the vendor ID. DFU
5844 003
Product ID Displays the product ID. DFU
5844 004
Dev. Release Num
Displays the development release version number. DFU
Exit
SP Mode (Service) Close All Copy Window SP DirectOpen All X-XXX-XXX
SP2XXX
SP3XXX
SP5XXX
SP6XXX
SP7XXX
SP8XXX
SP4XXX
SP1XXX Group
Page
Line
Page
Line
Group
21
COPY: SP1-001-001
Initial 0
Prev Page Next Page
14APR 2002 03:25
Feed
Drum
Process
Data Log2
Scanner
Mode
Periphs
Data Log
B064I999.WMF