Toshiba e-STUDIO4500c/5500c service manual

SERVICE PROGRAM TABLES April, 2007
5-58
2526 LEdge Cor:Thk:FC Leading Edge Correction for Thick Paper: K
This SP sets the coefficient used to 1) correct bias at the leading edge for full -color
image transfer (ITB) bias at image to paper transfer when using thick paper
(128~256 g/m2), and 3) correct the dc and ac voltages applied at paper separation.
Notes: These settings apply:
• Only the distance from the leading edge set with SP2527.
• Only to full color printing on thick paper at half speed.
001 ITB [0~400/1%]
007 Side1:PTR [0~400/1%]
008 Side1:SepDC [0~400/1%]
009 Side1:SepAC
012 Side2:PTR [0~400/1%]
013 Side2:SepDC [0~400/1%]
014 Side2:SepAC
2527
LEdge SWT:Thk:FC Leading Edge Switch Timing for Thick Paper: FC
This SP sets switch timing that sets the distance from the leading edge where the
settings of SP2526 001 are to apply. The value selected is the number of mm from
the leading edge of the paper. These settings 1) apply only full-color printing on thick
paper (128~256 g/m2) at half speed, and 2) apply to to both sides of a duplex page.
001 ITB [0~30/1 mm]
002 PTR [0~30/1 mm]
003 SepDC [0~30/1 mm]
004 SepAC
2528
TEdge Cor:Thk FC Trailing Edge Correction for Thick Paper: FC
This SP sets the coefficient used to correct bias at image to paper transfer for each
side of the paper. These settings are applied to the trailing edge for full-color printing
on thick paper (128~256 g/m2) at half speed as far as where SP2529 002 takes
effect.
007 Side1:PTR [0~400/1%]
012 Side2:PTR
2529
TEdge Cor:Thk:FC – PTR Trailing Edge Correction for Thick Paper: FC
002 This setting sets the start timing for application of SP2528 007, 2528 012 at the
trailing edge of each sheet (Side 1, Side 2). These settings are applied to the trailing
edge for black printing on plain paper at full speed and apply to black, even when
printing in full color mode.
[-100~0/1 mm]
The mm distance is measured away from the trailing edge of the image.