ADDITIONAL INFORMATIONS April 2007
4-114
ADJUSTING THE NIP WIDTH:
1. Remove the fusing unit from the copier and place it on the table.
2. Make sure the pressure levers ([I], [J]) are in the upper position as shown in
Photo A.
NOTE: If the levers are not in the upper position, pressure will not be applied
between the fusing belt and pressure roller.
3. Turn screws [G] and [H] to bring the nip width to within specification.
• To increase the nip width, turn the screws clockwise.
• To decrease the nip width, turn the screws counter-clockwise.
NOTE: One turn of the screw changes the nip width about 0.3mm.
[G]
[H]
[G]
[H]
Clockwise direction
Clockwise direction
[I] [J]
Photo A: OK
[I] [J]
Photo B: NG
07/04