April, 2007 SERVICE CALL CONDITIONS
4-27
4.3.3 SC CODE DESCRIPTIONS
Important
• If a problem concerns a circuit board, disconnect and reconnect the connectors
and then test the machine. Often a loose or disconnected harness is the cause
of the problem. Always do this before you decide to replace the PCB.
• If a motor lock error occurs, check the mechanical load before you decide to
replace the motor or sensors.
• W hen a Level “A” or “B” SC occurs while in an SP mode, the machine cannot
display the SC number. If this occurs, check the SC number after leaving the SP
mode.
• The machine reboots automatically when the machine issues a Level “D” SC
code. This is done for Level “D” SC codes only. (4.3.2)
CAUTION
Never turn OFF the main power switch when the power LED is lit or
flashing. To avoid damaging the hard disk or memory, press the operation
switch to switch the power OFF, wait for the power LED to go OFF, and
then switch the main power switch OFF.
NOTE: The main power LED ( ) lights or flashes while the platen cover or
ARDF is open, while the main machine is communicating with the network
server, or while the machine is accessing the hard disk or memory for
reading or writing data.