ADDITIONAL INFORMATIONS April 2007
4-110
5. Select the Paper Thickness Setting to "Normal Paper" for the tray, on which you
need to apply "Middle Thickness Paper Mode."
User Tools Æ System Settings Æ Tray Paper Settings Æ Paper Thickness Setting
Then, select "Normal (72-126g/m2)” for the tray.
6. Change the Fusing Temperature settings according to the type of "Middle
Thickness Paper Mode", which is most appropriate for the poor fusing symptom.
1) "Middle Thickness Paper Mode -1" (Default)
NOTE: This setting is effective both for poor fusing and the sponge
image/separation pawl streaks. You do NOT have to change any SP
settings (Default settings are OK).
a) SP1105-013 (Htg Roll Sn1: Ctr / 1-S: Thk3: FC: NS: CPM)
Default:180.
b) SP1105-021 (Htg Roll Sn1: Ctr / 2-S: Thk3: FC: NS: CPM
Default: 180.
2) "Middle Thickness Paper Mode -2"
NOTE: NOTE: This setting should be selected if the effectiveness of "Middle
Thickness Paper Mode-1" is not enough for the poor fusing. However,
with this setting, it is easier for separation pawl streaks to occur.
Change the following SP setting as a set.
a) SP1105-013 (Htg Roll Sn1: Ctr / 1-S: Thk3: FC: NS: CPM)
Change to 185 (default: 180)
b) SP1105-021 (Htg Roll Sn1: Ctr / 2-S: Thk3: FC: NS: CPM
Change to 185 (default: 180)
07/04