Toshiba e-STUDIO4500c/5500c Fusing Anti-glossy Streak Kit (P/N B1329713):

April, 2007 ADDITIONAL INFORMATIONS
4-103
Fusing Anti-glossy Streak Kit (P/N B1329713):
Detailed part information:
The kit consists of the following parts (see illustration “Parts Locations” on next
page):
Gear Hot Roller: 44Z [A]
Gear Upper 52Z [B]
Gear 49Z [C]
Pressure Roller D50 [D]
Important Notes:
1. This kit is only effective for Type A and Type C explained above.
2. After you install this kit for Type A, it may take some time before the image
quality improves. If the customer does not wish to wait, replace the fusing belt.
3. After you install this kit, the line speed of the fusing belt is 6% faster than the
line speed of the pressure roller. (Default: Same speed). As a result, the yield of
the fusing belt changes from 600K to 300K.
4. After you install the kit, make a visible mark on the outside of the fusing unit.
Example: Write, “Fusing anti-glossy streaks kit installed” on the outside of the
fusing unit.
This is because the parts in this kit are not available as individual service parts.
They are different from the service parts listed in MB132001.
5. In the future, if any of the four parts above needs to be replaced, and there is a
mark on the fusing unit like the example above, make sure to install the whole
Fusing Anti-glossy streak kit. In such a case, do not use the parts in MB132001.
06/10