COPIER E-STUDIO4500C/5500C August, 2006
1-26
Reinstall the Toner Hopper
1. Make sure that the transfer belt release lever [A] is up and locked before you
attach the hopper.
2. Pull the toner hopper left rail [B] and right rail [C] until they are fully extended.
NOTE: If the rails were pushed in fully, it could be necessary to use a pair of
needle-nose pliers to pull them out of the machine.
3. Set the toner hopper [D] on the rails.
Important: Make sure the steel tabs [E] of the hopper are put fully into the left
rail hole and the right rail hole [F].
4. Push the lock [G] and push the support leg [H].
Important: Make sure that the support leg is up and locked before you push
the toner hopper into the machine.
5. Put your hands at the bottom of the toner hopper at and and then push
the hopper into the machine against the face plate.
Important: To prevent damage to the hopper, do not push the top of the toner
hopper when you do this step.
6. Make sure that the hopper is flat against the face plate on the right side.
NOTE: If the toner hopper [D] is not flat against the face plate on the right side,
pull it out a short distance and make sure that the transfer belt release
lever is turned up fully.
7. Attach the toner hopper ( x 3). Attach the screws in this sequence: 
B132I006.WMF
[A]
[D]
[G]
[C]
[B]
[H]
[E]
[F]