April, 2007 SERVICE CALL CONDITIONS 4-69
HDD re-try failure
SC861
D
At power ON with the HDD
detected, power supply to the HDD
is interrupted, after the HDD is
awakened from the sleep mode, the
HDD is not ready within 30 s.
• Harness between HDD and board
disconnected, defective
• HDD power connector disconnected
• HDD defective
• Controller board defective
HDD data read failure
SC863
D
The data written to the HDD cannot
be read normally, due to bad
sectors generated during operation.
• HDD defective
Note: If the bad sectors are generated at
the image partition, the bad sector
information is written to NVRAM, and the
next time the HDD is accessed, these bad
sectors will not be accessed for read/write
operation.
HDD data CRC error
SC864
D
During HDD operation, the HDD
cannot respond to an CRC error
query. Data transfer did not execute
normally while data was being
written to the HDD.
• HDD defective
HDD access error
SC865
D
HDD responded to an error during
operation for a condition other than
those for SC863, 864.
• HDD defective.
SD card error 1: Confirmation
SC866
B
The machine detects an electronic
license error in the application on
the SD card in the controller slot
immediately after the machine is
turned ON.
The program on the SD card
contains electronic confirmation
license data. If the program does
not contain this license data, or if
the result of the check shows that
the license data in the program on
the SD card is incorrect, then the
checked program cannot execute
and this SC code is displayed.
• Program missing from the SD card
• Download the correct program for the
machine to the SD card
SD card error 2: SD card removed
SC867
D
The SD card in the boot slot when
the machine was turned on was
removed while the machine was
ON.
• Insert the SD card, then turn the machine
OFF and ON.