SERVICE PROGRAM TABLES August, 2006

5-116

5821 Remote Service Address (Japan Only)
001 CSS PI Device Code Sets the PI device code. After you change this
setting, you must turn the machine off and on.
002 RCG IP Address Sets the IP address of the RCG (Remote
Communication Gate) destination for call
processing at the remote service center.
[00000000h~FFFFFFFFh/1]
5824 NVRAM Data Upload
Uploads the NVRAM data to an SD card (B6455010). Press Execute.
Note: When uploading in this SP mode data, the front door must be open.
5825 NVRAM Data Download
Downloads data from an SD card to the NVRAM in the machine. After
downloading is completed, remove the card and turn the machine power off and
on.
5828 Network Setting
050 1284 Compatibility
(Centro) Enables and disables bi-directional communication
on the parallel connection between the machine and
a computer.
[0~1/1]
0:Off
1: On
052 ECP (Centro) Disables and enables the ECP feature (1284 Mode)
for data transfer.
[0~1/1]
0: Disabled
1: Enabled
065 Job Spool Setting Switches job spooling spooling on and off.
0: No spooling 1: Spooling enabled
066 Job Spool Clear This SP determines whether the job interrupted at
power off is resumed at the next power on. This SP
operates only when SP5828 065 is set to 1.
1: Resumes printing spooled jog.
0: Clears spooled job.
069 Job Spool Protocol This SP detemines whether job spooling is enabled
or dispabled for each protocol. This is a 8-bit setting.
0
LPR 4 BMLinks (Japan Only)
1
FTP (Not Used) 5 DIPRINT
2
IPP 6 Reserved (Not Used)
3
SMB 7 Reserved (Not Used)
077 IPv4 DNS Server 2
078 IPv4 DNS Server 3 Sets the IPv4 address for a DNS server. This address
can be used among devices that have IPv4 devices
(Ethernet, IPv4 Over 1394, IEEE 802.11b, etc.)
079 Domain Name (Ethernet)
084 Setting List Print Prints a list of the NCS parameter settings.