Xerox 180 IPS manual Configuration steps AS/400, Configuration worksheet

				DEFINING THE PRINTER TO THE HOST: TCP/IP ATTACHMENT
Configuration steps – AS/400
			Follow these steps to configure your AS/400 to print to an IPS printer
			connected to the LAN, using TCP/IP.
	Configuration worksheet		The following worksheet will help you in planning the IPS installation.
			It describes the key values which you need to supply when planning
			the AS/400 configuration. All values on this worksheet must be
			determined before you begin the printer configuration on the host.
			Table E-14.AS/400 configuration worksheet for IPS
	Item description	Also known as...		Source	Your value
	Device description	DEVD		This is the name of the printer (writer).
				An Output Queue of the same name is
				automatically created. Spool files that
				you place in this Output Queue are
				directed to the printer.
	Remote location	RMTLOCNAME		Xerox IPS software installation. This is
				the printer IP address.
	Port number	PORT		IPS configuration Interface window and
				subwindows. The value 5001 works
				best for IPDS printers.
	PSF configuration	PSFCFG		Same as Device description
			Note: It is assumed that your AS/400 is connected to the LAN and
			all the prerequisite software is installed and configured.

1. Configure the IPS printer for TCP/IP at the GUI

Refer to the “Setting the system configuration” chapter of the Guide to Configuring and Managing the System for this graphical user interface (GUI) procedure.

2. Create the PSF/400 configuration

Follow these steps to configure PSF/400 for the IPS printer.

1.At the AS/400, press <F4> to prompt the CRTPSFCFG command.

2.Key in the parameter values as indicated in the figure below.

For parameters with * beside them, refer to the configuration worksheet, earlier in this section.

XEROX DOCUPRINT 96/4635/180 IPS INSTALLATION PLANNING GUIDE E-19