Xerox 180 IPS manual Floor leveling, Delivery access requirements, • • •

PRINTER SPECIFICATIONS AND REQUIREMENTS

Floor leveling

For proper operation, the printer must be perfectly level. On floors less than two degrees out of level, installation personnel use a leveling kit to level the machine.

Note: The printer will not function properly on floors more than two degrees out of level.

If the floor is more than two degrees out of level, this condition cannot be corrected by the leveling kit. Another suitable location must be found for the printer to be installed properly.

For your reference, two degrees represents a height discrepancy of approximately 3.8 inches / 9.6 cm measured at the casters with the printer tilting from left to right, or approximately 0.7 inches / 1.8 cm with the printer tilting from back to front.

If you move the printer unit after its initial installation, it is your responsibility to make sure that the printer can be leveled properly. If you do not have the leveling kit (the printer in its initial location did not require it), and you need one to level the printer in a new location, contact your Xerox site representative to obtain one.

Delivery access requirements

It is easy to overlook the path required to move the equipment from the truck to the operation site. To determine access, ask the following questions:

•

•

Does the equipment need to go up stairs?

Do you have an elevator, if the equipment is to be located above the first floor?

•

•

•

Is the elevator large enough for the equipment?

How wide are the hallways and doorways?

Do you have a loading dock or a specific door to which the equipment should be delivered?

You need to review these issues prior to, or at the time of, the site inspection conducted by your service representative.

The equipment dimensions are specified earlier in this chapter, so it is easy to determine whether your hallways and doorways are wide enough to permit access.

6-24 XEROX DOCUPRINT 96/4635/180 IPS INSTALLATION PLANNING GUIDE