CONTROLLER SPECIFICATIONS AND REQUIREMENTS
Space requirements
The printer controller consists of the Sun workstation and, for
For printer component space requirements, refer to the “Printer specifications and requirements” chapter of this guide. Contact your service representative if you have questions not specifically addressed in this guide.
Printer controller placement
You should consider the following factors when deciding where to place the DocuPrint printer controller:
•Adequate work space and service clearance around the equipment
•
•
Proximity to electrical and network connectors
Security of the work area. You may need to place the system in an area where you can restrict access to it.
You must supply a table or desk as a work surface for both the printer controller and the HCU. The top of the table must provide at least 36 by 36 inches / 91.4 by 91.4 cm of space for each component, to allow enough space for the components and cables, as well as for service access.
Refer to the “Printer controller specifications and requirements” summary table at the end of this chapter to make sure the tables you supply can support the weight of the printer controller hardware elements and of the HCU, and that they are suitable for the intended use.
Warning: The printer controller must be positioned within the line-
!
Caution: Position the table at least 6 inches / 15.2 cm from the wall. Make sure the workstation processor and the HCU are at least
12 inches / 30.4 cm from the wall. Do not put the processor or the HCU on the IPSLPS printer. 
XEROX DOCUPRINT 96/4635/180 IPS INSTALLATION PLANNING GUIDE |
