Chapter8: Configuring ATM Virtual Circuits
Avidia System Configuration and Management User Manual 179
Configuring Frame Channel Card PVCCs
You can configure cross-connect PVCCs between frame-based channel cards and line cards or
the management card. You configure PVCCs from the ::pvcc=> prompt. From the
::root=> prompt, type the following command then press to display the ::pvcc=>
prompt.
configuration atm frame pvc

Adding Frame Channel Card PVCCs

From the ::pvcc=> prompt, do one of the following:
•To add one PVCC, type the new command in the following format then press . The
PVCC table index number is automatically assigned.
new <cport> <lport> <lvpi> <lvci> [-mode (vcmux|llc)]
[-admin (up|down)][-txtraf <index>] [-rxtraf <index>]
[-backup [<lport> <vpi> <vci>]]
•To add multiple PVCCs with the same traffic profile, type the range command in the
following format then press .
range <#pvcs> <cport> <lslot> <lvpi> <lvci>
[-mode (vcmux|llc)] [-admin (up|down)] [txtraf <index>]
[-rxtraf <index>] [-y]
Parameters
<#pvcs>
The number of PVCCs you want to create with the same traffic profile. See the table on
page 24 to verify that the ports you plan to use for the PVCCs support the number of
PVCCs you intend to create.
<cport>
The channel card slot number or slot and port number for the PVCC. To map the PVCC to
a specific service type on a specific port, specify slot.port. Otherwise, use the format slot.
For frame channel cards, the VPI is always zero and the system automatically
assigns the VCI. Therefore, you do not enter this information during frame
channel card PVCC configuration.
ENTER
ENTER
ENTER