Chapter17: System Maintenance and Administration
Avidia System Configuration and Management User Manual 347
Parameters
[-loopback (none|local|line|payload|remote)]
The type of loopback to start. See the table on page345 for information. Type none to
cancel the loopback.
Examples
::ds1=> 2.1 -loopback payload
::ds1=> 2.1 -loopback none
Initiating DS3 Loopbacks
Configure DS3 service from the ::ds3=> prompt. From the ::root=> prompt, type the
following command then press to display the ::ds3=> prompt.
configuration ds3
From the ::ds3=> prompt, type the set command in the following format then press .
set <port> [-loopback (none|local|line|remote)]
Parameters
[-loopback (none|local|line|remote)]
The type of loopback to start. See the table on page345 for information. Type none to
cancel the loopback.
Examples
::ds3=> set 12.1 -loopback local
::ds3=> set 12.1 -loopback none
The set command is also used to configure DS3 ports. See “Configuring DS3
Service” on page149 for information about DS3 port configuration
parameters.
ENTER
ENTER